Sequoia LTD 4WD V8-4.7L (2UZ-FE) (2001)
Wheel Speed Sensor: Service and Repair
Speed Sensor, Front
Front
REMOVAL
1. REMOVE FRONT WHEEL
Torque: 110 Nm (1,150 kgf-cm, 83 ft. lbs.)
2. DISCONNECT SPEED SENSOR CONNECTOR
3. REMOVE SPEED SENSOR
(a) Remove the clips and 3 clamp bolts holding the sensor harness from the frame, upper arm and steering knuckle.
Torque: 8.0 Nm (82 kgf-cm, 71 inch lbs.)
(b) Remove the bolt and speed sensor from the steering knuckle.
Torque: 8.0 Nm (82 kgf-cm, 71 inch lbs.)
INSTALLATION
Installation is in the reverse order of removal.
HINT: After installation, check speed sensor signal