Sequoia LTD 4WD V8-4.7L (2UZ-FE) (2001)
Wheel Speed Sensor: Service and Repair
Speed Sensor, Rear
Rear
REMOVAL
1. DISCONNECT SPEED SENSOR CONNECTOR
2. REMOVE SPEED SENSOR
(a) Remove the 6 resin clips holding the sensor wire harness.
(b) Remove the bolt and speed sensor from the axle carrier.
Torque: 8.0 Nm (82 kgf-cm, 71 inch lbs.)
INSTALLATION
Installation is in the reverse order of removal.
HINT: After installation, check speed sensor signal