Sequoia LTD 4WD V8-4.7L (2UZ-FE) (2001)
Parking Brake Pedal: Service and Repair
REMOVAL
1. REMOVE FRONT DOOR SCUFF PLATE, COWL SIDE TRIM, SIDE PANEL, LOWER FINISH PANEL AND NO. 2 HEATER TO
REGISTER DUCT
2. REMOVE PARKING BRAKE PEDAL ASSEMBLY
(a) Disconnect the parking brake switch connector.
(b) Remove the lock nut and adjusting nut from the parking brake wire.
Torque: 5.4 Nm (55 kgf-cm, 48 inch lbs.)
(c) Remove the clip and disconnect the parking brake wire from the parking brake pedal assembly.
(d) Remove the 4 bolts and parking brake pedal assembly.
Torque: 13 Nm (130 kgf-cm, 9 ft. lbs.)
DISASSEMBLY
1. REMOVE RETURN SPRING AND RETURN SPRING DAMPER