Sequoia LTD 4WD V8-4.7L (2UZ-FE) (2001)
/Page-378003.png)
b. Install the LH camshafts.
1. Apply MP grease to the thrust portion of the intake and exhaust camshafts.
2. Place the intake and exhaust camshafts.
3. Engage the intake gear to the exhaust gear by meeting the timing marks (2 dot marks) on each gear.
4. Remove any old packing (FIPG) material.
5. Apply seal packing to the front bearing cap.
Seal packing:Part No. 08826-00080 or equivalent
-
Install a nozzle that has been cut to a 1.5 mm (0.06 inch) opening.
-
Parts must be assembled within 5 minutes of application. Otherwise the material must be removed and reapplied.
-
Immediately remove nozzle from the tube and reinstall cap.
NOTICE: Do not apply seal packing to the front bearing cap grooves.
6. Install the front bearing cap.
HINT: Installing the front bearing cap will determine the thrust portion of the camshaft.
7. Install the other bearing cap in the sequence shown with the arrow mark facing forward.
HINT: Align the arrow marks at the front and rear of the cylinder head with the mark on the bearing cap.
8. Push in the camshaft oil seal.