Sequoia LTD 4WD V8-4.7L (2UZ-FE) (2001)
9. Apply a light coat of engine oil on the threads and under the heads (D and E) of the bearing cap bolts.
HINT: Do not apply engine oil under the heads of the bearing cap bolt (A), (B)and (C).
10. Install the oil feed pipe and 22 bearing cap bolts as shown.
HINT: Each bolt length is indicated in the illustration.
Bolt length:
25 mm (0.98 inch) for A
38 mm (1.50 inch) for B
52 mm (2.05 inch) for C
72 mm (2.83 inch) for D
94 mm (3.70 inch) for E
11. Uniformly tighten the 22 bearing cap bolts in several passes, in the sequence shown.
Torque:
Bolt A: 7.5 Nm (80 kgf-cm, 69 inch lbs.)
Others 16 Nm (160 kgf-cm, 12 ft. lbs.)
12. Boring the service bolt installed in the driven sub-gear upward by turning the hexagon wrench head portion of the camshaft with a wrench.
13. Remove the service bolt.