toyota Workshop Repair Guides

Toyota Workshop Manuals

< PREV PAGE NEXT PAGE >
Page 1
background image

Body Control System: Customer Interest
Headlight High Beam Indicator Light - Inoperative

ELECTRICAL
EL007-01

September 7, 2001

Title:
HIGH BEAM INDICATOR LIGHT INOPERATIVE

Models:
'01 Sequoia

Introduction

In rare cases, some owners of 2001 model year Sequoia vehicles equipped with Daytime Running Lights (DRLs) may experience a condition in which
the High Beam Indicator Light does not illuminate when the high beams are turned on. A modification to the wiring harness and replacement of the Body
ECU, as described below, should be performed to correct this condition.

Applicable Vehicles
^

2001 model year Sequoia vehicles with Daytime Running Lights (DRLs).

Production Change Information

Parts Information

Warranty Information

Applicable Warranty*:
This repair is covered under the Toyota Comprehensive Warranty. This warranty is in effect for 36 months or 36,000 miles, whichever occurs first, from
the vehicle's in-service date.

* Warranty application is limited to correction of a problem based upon a customer's specific complaint.

Repair Procedure

1.

Modify the high beam indicator circuit wiring.

A.

Remove the Combination Meter. See page BO-88 in the 2001 Sequoia Repair Manual.

B.

Locate connector C7 at the back of the combination meter.

Relays and Modules > Relays and Modules - Powertrain Management > Relays and Modules - Computers and Control Systems > Body Control System <--> [Body Control Module] > Component Information > Technical Service Bulletins > Customer Interest for Body Control System: > EL007-01 > Sep > 01 > Headlight High Beam Indicator Light - Inoperative

< PREV PAGE NEXT PAGE >