Sequoia LTD 4WD V8-4.7L (2UZ-FE) (2001)
/Page-1456004.png)
a. Install the 4 bolts.
Torque: 43 N.m (440 kg.cm, 32 ft.lb)
NOTE:
-
Make sure that the seatback assembly is installed with the specified torque.
-
If the seatback assembly has been dropped, or there are cracks, dents or other defects in the case or connector, replace the seatback
assembly with a new one.
-
When installing the seatback assembly, take care it is not pinched between other parts.
b. Install 3 new hog rings as shown in the illustration.
HINT: When installing new hog rings, take care to prevent wrinkles as much as possible.
c. Install the wire harness to the reclining adjuster inside cover.
3. INSTALL FRONT SEAT CUSHION INNER SHIELD
Install the front seat cushion inner shield with the 2 screws.
