Sequoia LTD 4WD V8-4.7L (2UZ-FE) (2001)
/Page-1486008.png)
-
Never use seat belt pretensioner from another vehicle. When replacing parts, replace them with new parts.
-
Make sure that the front seat outer belt is installed to the specified torque.
-
If the front seat outer belt has been dropped, or there are cracks, dents or other defects in the case or connector, replace the front seat outer belt
with a new one.
-
When installing the front seat outer belt, take care that the wiring does not interfere with other parts and is not pinched between other parts.
1. Other front seat outer belts: INSTALL RETRACTOR OF FRONT SEAT OUTER BELT
a. Install the retractor of front seat outer belt with the 2 bolts.
Torque: 42 N.m (430 kg.cm, 31 ft.lb)
b. Connect the pretensioner connector as shown in the illustration.
2. INSTALL LOWER CENTER PILLAR GARNISH
a. Install the lower center pillar garnish.
b. Install the front seat outer belt floor anchor.
Torque: 42 N.m (430 kg.cm, 31 ft.lb)
3. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP
4. INSTALL REAR DOOR SCUFF PLATE
5. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP
6. INSTALL FRONT DOOR SCUFF PLATE
