Sequoia LTD 4WD V8-4.7L (2UZ-FE) (2001)
Seat Belt Tensioner: Removal and Replacement
SEAT BELT PRETENSIONER
REMOVAL
NOTE:
-
If the wiring connector of the supplemental restraint system is disconnected with the ignition switch at ON or ACC, diagnostic trouble codes will
be recorded.
-
Never use SRS parts from another vehicle. When replacing parts, replace them with new parts.
1. REMOVE FRONT DOOR SCUFF PLATE
Remove the 4 screws and front door scuff plate.
2. REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP
3. REMOVE REAR DOOR SCUFF PLATE
a. Remove the 3 screws.
b. Using a screwdriver, remove the rear door scuff plate.
HINT: Tape the screwdriver tip before use.
4. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP
5. REMOVE LOWER CENTER PILLAR GARNISH
a. Remove the front seat outer belt floor anchor.
b. Using a screwdriver, remove the lower center pillar garnish.
HINT: Tape the screwdriver tip before use.
6. REMOVE RETRACTOR OF FRONT SEAT OUTER BELT