Sequoia LTD 4WD V8-4.7L (2UZ-FE) (2001)
12. REMOVE CONTROL VALVE ASSEMBLY
a. To prevent oil seal lip damage, wind vinyl tape on the serrated part of the valve shaft.
b. Press out the valve assembly with the oil seal.
NOTICE:
^
Place a shop rag between the valve housing and the blocks.
^
Be careful not to drop the valve assembly.
^
Be careful not to damage the oil seal lip.
13. REMOVE OIL SEAL
Remove the oil seal from the control valve assembly.
14. REMOVE CYLINDER END STOPPER
a. Using SST, turn the stopper clockwise until the wire end is visible through the service hole.
SST 09631-16010
b. Using SST, turn the stopper counterclockwise, and remove the wire.
SST 09631-16010
15. REMOVE STEERING RACK AND BUSHING
a. Using SST, press out the steering rack with the bushing
NOTICE: Take care not to drop the rack.
SST 09950-70010 (09951-07200)
b. Remove the bushing from the rack.
c. Remove the O-ring from the bushing.