Sequoia LTD 4WD V8-4.7L (2UZ-FE) (2001)
3. DISCONNECT UPPER BALL JOINT
a. Remove the cotter pin and loosen the nut.
b. Using Special Service Tool (SST), disconnect the upper ball joint.
SST 09950-40011 (09951-04010, 09952-04010, 09953-04020, 09954-04010, 09955-04031, 09958-04011)
c. Support the steering knuckle securely.
d. Remove the nut.
4. REMOVE FENDER APRON SEAL REAR
Remove the 4 clips and fender apron seal rear.
5. REMOVE BRAKE AND FUEL LINE CLAMP
Disengage the 2 brake lines and fuel line, and remove the nut and brake line clamp.
6. REMOVE UPPER SUSPENSION ARM
Remove the nut, bolt, 2 washers and upper suspension arm.
REPLACEMENT
1. REMOVE BUSHING
a. Using a chisel and hammer, pry up the flange of the bushing.
b. Using Special Service Tool (SST) and a press, remove the bushing.
SST 09613-26010, 09631-20060, 09950-00020