Sequoia LTD 4WD V8-4.7L (2UZ-FE) (2001)
/Page-1011002.png)
4. REMOVE DRIVE SHAFT LOCK NUT
a. Using a screwdriver and hammer, remove the grease cap.
b. Remove the cotter pin and lock cap.
c. While applying the brakes, remove the lock nut.
5. DISCONNECT LOWER SUSPENSION ARM FROM LOWER BALL JOINT
a. Remove the cotter pin and nut.
b. Using Special Service Tool (SST), disconnect the lower suspension arm from the lower ball joint.
SST 09628-62011
6. DISCONNECT DRIVE SHAFT FROM STEERING KNUCKLE
a. Using a plastic hammer, disengage the drive shaft from the axle hub.
b. Push the steering knuckle outward and disconnect the drive shaft from the steering knuckle.
NOTICE: Be careful not to damage the oil seal, boots and dust seal.
7. Left-Hand drive shaft: REMOVE LEFT-HAND SHOCK ABSORBER
