Sequoia LTD 4WD V8-4.7L (2UZ-FE) (2001)
e. Remove the SST
SST 09521-25011, 09521-25021
4. REMOVE OIL DEFLECTOR AND GASKET
Using a brass bar and hammer, remove the 6 hub bolts, oil deflector and gasket.
5. REMOVE BEARING ASSEMBLY
Attach 4 nuts to the serration bolts and remove the serration bolts from the backing plate using a hammer.
NOTICE: Do not reuse the nuts previously removed from the vehicle.
INSPECTION
INSPECT AXLE SHAFT
Using a dial indicator, measure the runout of the shaft and flange.
Maximum shaft runout: 2.0 mm (0.079 inch)
Maximum flange runout: 0.1 mm (0.0040 inch)
If the rear axle shaft or flange are damaged or worn, or if runout is greater than the maximum, replace the rear axle shaft.
REPLACEMENT
REPLACE OIL SEAL (INNER SIDE)
a. Using Special Service Tool (SST), remove the oil seal.
SST 09308-00010