Sequoia LTD 4WD V8-4.7L (2UZ-FE) (2001)
b. Using SST and a hammer, install a new oil seal.
SST 09950-60020 (09951-00710), 09950-70010 (09951-07150)
c. Coat MP grease to the oil seal lip.
REASSEMBLY
1. INSTALL BEARING ASSEMBLY
Position the backing plate on the bearing assembly and using a press and 2 socket wrenches, install the serration bolts.
2. INSTALL OIL DEFLECTOR AND GASKET
Position a new gasket and oil deflector on the axle shaft and install a washer and nut to a new hub bolt, as shown in the illustration, and install the
hub bolt by torquing the nut.
3. INSTALL REAR AXLE SHAFT TO BACKING PLATE
a. Install the backing plate, spring washer and bearing retainer on the rear axle shaft.
b. Using SST and a press, install the rear axle shaft into the backing plate.
SST 09631-12090, 09950-60020 (09951-01030)
4. INSTALL SNAP RING TO AXLE SHAFT