Sequoia LTD 4WD V8-4.7L (2UZ-FE) (2001)
d. Cut the adhesive by pulling the piano wire around it.
HINT: Cut the adhesive areas as shown in the illustration, leaving the adhesive where the clips are.
e. Push the piano wire through as shown in the illustration, cut off the adhered part to the clips.
f.
Remove the glass.
NOTE: Leave as much of the adhesive on the body as possible when cutting off the glass.
INSTALLATION
1. CLEAN AND SHAPE CONTACT SURFACE OF BODY
a. Using a knife, cut away any rough areas on the body.
HINT: Leave the adhesive on the body as much as possible.
b. Clean the cut surface of the adhesive with a shop rag saturated in cleaner.
HINT: Even if all the adhesive has been removed, clean the body.