Sienna AWD V6-3.3L (3MZ-FE) (2004)
42. INSTALL REAR AXLE CARRIER BUSH LH
a. Align the matchmarks on the axle beam assy with the 2 notches of a new bushing and temporarily install the bushing to the rear axle beam
assy.
b. Using SST, install the bushing to the axle beam.
SST 09710-04101, 09950-40011 (09951-04020, 09952-04010, 09953-04030, 09954-04020, 09955-04051, 09957-04010, 09958-04011),
09950-60010 (09951-00620)
NOTICE:
^
Hang the claw of SST to the bushing securely.
^
Do not scratch the rubber portion of the bushing.
^
Do not deform the bushing rib.
43. INSTALL REAR AXLE CARRIER BUSH RH
SST 09710-04101, 09950-40011 (09951-04020, 09952-04010, 09953-04030, 09954-04020, 09955-04051, 09957-04010, 09958-04011),
09950-60010 (09951-00620)
HINT: Install the RH side by the same procedure as the LH side.
44. INSTALL REAR BRAKE TUBE FLEXIBLE HOSE
a. Install the flexible hose and clip.
b. Using SST, connect the brake tube to the flexible hose.
Torque: 15 Nm (153 kgf-cm, 11 ft. lbs.)
SST 09023-00100
HINT: Install the RH side by the same procedures as the LH side.
45. TEMPORARILY TIGHTEN REAR AXLE BEAM ASSY
a. Support the rear axle beam assy with a jack.
b. Install the rear axle beam assy, 2 bolts and temporary tighten the 2 nuts.
46. INSTALL COIL SPRING REAR LH
47. INSTALL COIL SPRING REAR RH
HINT: Install the RH side by the same procedures as the LH side.