Sienna FWD V6-3.3L (3MZ-FE) (2006)
c) Using needle-nose pliers, install the tension spring.
d) Install the 2 bolts to the brake pedal bracket No. 3.
Torque: 19 Nm (194 kgf-cm, 14 ft. lbs.)
e) Install the stop light switch harness clamp to the brake pedal support sub-assembly.
f) Connect the stop light switch connector.
2. FULLY TIGHTEN BRAKE PEDAL SHAFT
a) Fully tighten the 2 brake pedal shafts.
Torque: 34 Nm (350 kgf-cm, 25 ft. lbs.)
3. INSTALL INSTRUMENT PANEL SAFETY PAD INSERT SUB-ASSEMBLY NO. 1
a) Install the instrument panel safety pad insert subassembly No. 1 with the 4 bolts.
4. INSTALL INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LOWER LH
a) Install the instrument panel finish panel subassembly lower LH with the 2 bolts.
5. INSTALL COWL SIDE TRIM BOARD LH
6. INSTALL FRONT DOOR SCUFF PLATE LH
7. INSPECT BRAKE PEDAL HEIGHT
8. CHECK PEDAL FREE PLAY
9. CHECK PEDAL RESERVE DISTANCE