Sienna FWD V6-3.3L (3MZ-FE) (2006)
3. INSTALL PARKING BRAKE PEDAL BRACKET PROTECTOR
a) Fit the convex part on a new parking brake pedal bracket protector into the concave part on the parking brake control pedal and turn the
parking brake pedal bracket protector counterclockwise.
b) Engaging the 2 claws, install the parking brake pedal bracket to the parking brake control pedal.
INSTALLATION
1. INSTALL PARKING BRAKE CONTROL PEDAL ASSEMBLY
a) Install the parking brake control pedal assembly with a bolt and the 2 nuts.
Torque: 39 Nm (398 kgf-cm, 29 ft. lbs.)
b) Connect the parking brake switch connector.
c) Connect the instrument panel junction block assembly w/ wiring harness connector with the 4 nuts.
Torque: 7.3 Nm (74 kgf-cm, 65 inch lbs.)
2. INSTALL REAR FLOOR SEAT LOCK COVER
3. INSTALL REAR FLOOR SEAT LOCK COVER
4. INSTALL REAR SEAT NO.1 ASSEMBLY
HINT:
^
Captain Seat Type
^
Center Seat Type
5. INSTALL FRONT SEAT ASSEMBLY LH
HINT:
^
Manual Seat Type
^
Power Seat Type
^
Fold Flat Type
6. INSPECT PARKING BRAKE PEDAL TRAVEL
7. ADJUST PARKING BRAKE PEDAL TRAVEL