Sienna FWD V6-3.3L (3MZ-FE) (2006)
d) Install the oil seal to the camshaft.
NOTICE:
^
Do not turn over the oil seal lip.
^
Insert the oil seal until it stops.
e) Remove any old packing material from the contact surface.
f) Apply seal packing to the No. 1 bearing cap as shown in the illustration.
Seal packing: Part No. 08826-00080 or equivalent
NOTICE:
^
Install the No. 1 bearing cap within 5 minutes after applying seal packing.
^
Do not expose the seal to engine oil within 2 hours after installing.
g) Install the 5 bearing caps in their proper locations.
h) Apply a light coat of engine oil on the threads of the bearing cap bolts.
i)
Using several steps, install and tighten the 10 bearing cap bolts uniformly in the sequence shown in the illustration.
Torque: 16 Nm (163 kgf-cm, 12 ft. lbs.)
4. INSTALL NO. 3 CAMSHAFT SUB-ASSEMBLY
NOTICE: Since the thrust clearance of the camshaft is small, the camshaft must be kept level while it is being removed. If the camshaft is not