Sienna FWD V6-3.3L (3MZ-FE) (2006)
f.
Using a screwdriver, disengage the 16 clips and remove the quarter trim panel assembly.
HINT: Tape the screwdriver tip before use.
6. REMOVE REAR WINDOW SIDE GARNISH ASSEMBLY
7. REMOVE NO. 1 REAR SEAT OUTER BELT ASSEMBLY (for 7-Passenger)
HINT: Refer to the instructions for disassembly of the rear No. 1 seat assembly (for captain seat type).
a. Remove the rear seatback board RH.
b. Remove the rear seat shoulder belt cover.
c. Remove the bolt, nut and No. 1 rear seat outer belt assembly.
8. REMOVE 3 POINT TYPE REAR SEAT BELT ASSEMBLY (for 8-Passenger)
a. Remove the nut and disconnect the 3 point type rear seat belt on the shoulder anchor side.
9. REMOVE NO. 2 REAR SEAT OUTER BELT ASSEMBLY
a. Using a screwdriver, disengage the 2 claws and remove the cover of the No. 2 rear seat outer belt assembly on the shoulder anchor side.
HINT: Tape the screwdriver tip before use.
b. Remove the bolt and disconnect the No. 2 rear seat outer belt assembly on the shoulder anchor side.
c. Remove the bolt on the retractor side and remove the No. 2 rear seat outer belt assembly.
INSTALLATION
1. INSTALL NO. 2 REAR SEAT OUTER BELT ASSEMBLY
NOTE: Do not disassemble the retractor.
a. Check the degree of tilt when the No. 2 rear seat outer belt assembly begins to lock the ELR.