Sienna FWD V6-3.3L (3MZ-FE) (2006)
Seat Position Sensor: Service and Repair
SEAT POSITION SENSOR
REMOVAL
1. PRECAUTION
CAUTION: Be sure to read "Air Bag Systems; Service Precautions" thoroughly before servicing.
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait for 90 seconds after disconnecting the cable to prevent the airbag working.
3. REMOVE FRONT SEAT ASSEMBLY (for Manual Seat)
4. REMOVE FRONT SEAT ASSEMBLY (for Power Seat)
5. REMOVE RECLINING ADJUSTER RELEASE HANDLE LH (for Manual Seat)
6. REMOVE VERTICAL SEAT ADJUSTER KNOB CAP (for Manual Seat)
7. REMOVE VERTICAL ADJUSTING HANDLE NO.2 (for Manual Seat)
8. REMOVE FRONT SEAT CUSHION SHIELD LH (for Manual Seat)
9. REMOVE SLIDE AND VERTICAL POWER SEAT SWITCH KNOB (for Power Seat)
10. REMOVE RECLINING POWER SEAT SWITCH KNOB (for Power Seat)
11. REMOVE FRONT SEAT CUSHION SHIELD ASSEMBLY
a. Remove the 5 screws and the front seat cushion shield assembly.
12. REMOVE SEAT SLIDE POSITION SENSOR PROTECTOR
a. Remove the seat slide position sensor protector from the seat position sensor.