Sienna FWD V6-3.3L (3MZ-FE) (2006)
/Page-291002.png)
13. REMOVE SEAT POSITION SENSOR
a. Disconnect the connector from the seat position sensor.
b. Using a "torx" socket wrench (T30), remove the "torx" screw and the seat position sensor.
INSTALLATION
1. INSTALL SEAT POSITION AIRBAG SENSOR
a. Check that the ignition switch is off.
b. Check that the negative battery (-) terminal is disconnected.
CAUTION: After disconnecting the negative battery terminal, wait for at least 90 seconds before starting the operation.
c. Using a feeler gauge 1 mm (0.039 in.), install the seat position sensor.
NOTE:
-
If the seat position sensor has been dropped, or there are any cracks, dents or other defects in the case or connector, replace it with a new
one.
-
When installing the seat position sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched
