Sienna FWD V6-3.3L (3MZ-FE) (2006)
Torque: 1.8 N.m (18 kgf.cm, 16 in.lbf)
c. Pull out the pin (pi 1.0 mm (0.039 in.)) from the generator brush holder.
5. INSTALL TERMINAL INSULATOR
a. Install the terminal insulator to the generator rectifier end frame.
NOTE: Pay attention the mounting orientation of the terminal insulator.
6. INSTALL GENERATOR REAR END COVER
a. Install the generator rear end cover with the 3 nuts.
Torque: 4.6 N.m (47 kgf.cm, 41 in.lbf)
7. INSTALL GENERATOR PULLEY
SST 09820-63010 (09820-06010, 09820-06020)
a. Install the generator pulley to the rotor shaft by tightening the pulley nut by hand.
b. Hold SST 1-A with a torque wrench, and tighten SST 1-B clockwise to the specified torque.
Torque: 39 N.m (400 kgf.cm, 29 ft.lbf)