Sienna FWD V6-3.3L (3MZ-FE) (2006)
b. Remove the 2 nuts on the lower side of the shock absorber. (Procedure B)
NOTICE: When removing the nut, hold the bolt not to rotate.
c. Clean the installation surfaces of the shock absorber and the steering knuckle.
d. Temporarily install the 2 nuts.
e. Adjust the camber by pushing or pulling the lower side of the shock absorber in the direction in which the camber adjustment is required.
f.
Tighten the nuts.
Torque: 210 Nm (2,140 kg-cm, 155 ft. lbs.)
NOTICE: When installing nut, stop the bolt from rotating and torque the nut.
g. Install the front wheel.
Torque: 103 Nm (1,050 kg-cm, 76 ft. lbs.)