Sienna FWD V6-3.3L (3MZ-FE) (2006)
11. INSTALL STEERING RACK END SUB-ASSEMBLY
a. Install 2 new claw washers, and temporarily install the 2 steering rack end sub-assembly.
HINT: Align the claws of the claw washer with the power steering rack grooves.
b. Using 2 SST, install the 2 rack end sub-assembly.
SST 09922-10010
Torque: 58.5 Nm (597 kg-cm, 43 ft. lbs.)
NOTICE: Use SST 09922-10010 in the direction shown in the illustration.
HINT:
^
Using SST, hold the power steering rack and install the rack end sub-assembly.
^
Use a torque wrench with a fulcrum length of 345 mm (13.58 inch).
c. Using a brass bar and a hammer, stake the 2 claw washers.
NOTICE: Avoid any impact to the power steering rack.
12. INSPECT STEERING RACK END SUB-ASSEMBLY
a. Ensure that the rack end sub-assembly hole is not clogged with grease.
HINT: If the hole is clogged, the pressure inside the boot will change after it is assembled and steering wheel is turned.