Sienna FWD V6-3.3L (3MZ-FE) (2006)
13. INSTALL STEERING RACK BOOT NO.2
14. INSTALL STEERING RACK BOOT NO.1
15. INSTALL STEERING RACK BOOT NO.2 CLAMP
a. Using SST, tighten the rack boot No.2 clamp, as shown in the illustration.
SST 09521-24010
Clearance: 3.0 mm (0.118 inch) or less
NOTICE: Be careful not to damage the rack boot No.2.
16. INSTALL STEERING RACK BOOT NO.1 CLAMP
SST 09521-24010
HINT: Perform the same procedure on the other side.
17. INSTALL STEERING RACK BOOT CLIP
a. Using pliers, install the 2 rack boot clips.
18. INSTALL TIE ROD ASSEMBLY LH
a. Screw the lock nut and tie rod assembly onto the rack end sub-assembly until the matchmarks are aligned.
HINT: After adjusting toe-in, torque the lock nut.
19. INSTALL TIE ROD ASSEMBLY RH
HINT: Perform the same procedure on the other side.
20. INSTALL STEERING LEFT TURN PRESSURE TUBE
a. Coat 2 new O-rings with power steering fluid and install them onto the left turn pressure tube.
b. Using SST, install the left turn pressure tube onto the power steering gear assembly.
SST 09023-38201
Torque: 11.5 Nm (117 kg-cm, 8 ft. lbs.)
HINT:
^
Use a torque wrench with a fulcrum length of 345 mm (13.58 inch).
^
This torque value is effective when SST is parallel to the torque wrench.
21. INSTALL STEERING RIGHT TURN PRESSURE TUBE
SST 09023-38201
HINT: Perform the same procedure on the other side.