Sienna FWD V6-3.3L (3MZ-FE) (2006)
3. INSTALL COWL TOP PANEL SUB-ASSEMBLY OUTER FRONT
a. Install the cowl top brace and cowl top panel sub assembly outer front with the 9 bolts.
Torque: 7.5 Nm (76 kg-cm, 66 inch lbs.)
b. Connect the wire harness to the cowl top panel subassembly outer front.
4. INSTALL WINDSHIELD WIPER MOTOR & LINK ASSEMBLY
5. INSTALL FR WIPER ARM LH
6. INSTALL FR WIPER ARM RH
7. INSTALL FRONT WHEEL
Torque: 103 Nm (1,050 kg-cm, 76 ft. lbs.)
8. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT
DISPOSAL
1. DISPOSE OF SHOCK ABSORBER ASSEMBLY FRONT LH
HINT: Dispose the RH side by the same procedures as the LH side.
a. Fully extend the shock absorber rod.
b. Using a drill, make a hole in the cylinder as shown in the illustration to discharge the gas inside.
CAUTION:
^
When drilling, chips may fly out, work carefully.
^
The gas is colorless, odorless and nonpoisonous.