Sienna FWD V6-3.3L (3MZ-FE) (2006)
c. Remove the bolt and separate the brake tube from rear axle beam assembly.
13. SEPARATE REAR BRAKE TUBE NO.1
SST 09023-00101
HINT: Separate the RH side by the same procedures as the LH side.
14. REMOVE FUEL TANK FILLER HOSE COVER
a. Remove the 2 bolts, 3 screws, 3 nuts and fuel tank filler pipe protector.
b. Remove the 3 bolts and fuel tank filler hose cover.
15. REMOVE REAR FLOOR NO.2 CROSSMEMBER BRACE LH
a. Remove the 2 bolts and floor No.2 crossmember brace.
16. REMOVE REAR FLOOR NO.2 CROSSMEMBER BRACE RH
HINT: Remove the RH side by the same procedures as the LH side.
17. LOOSEN REAR AXLE BEAM ASSEMBLY
a. Refer to hint below.
HINT: Loosen the RH side by the same procedures as the LH side.
NOTICE:
^
When loosening the bolt, hold the nut not to rotate.
^
Do not remove the bolt and nut.
18. SEPARATE SHOCK ABSORBER ASSEMBLY REAR LH
a. Support the rear axle beam assembly with a jack.