Sienna FWD V6-3.3L (3MZ-FE) (2006)
Continuously Variable Transmission/Transaxle: Technical Service Bulletins
A/T, M/T - Alignment Pin Service Precaution
T-SB-0053-08
May 8, 2008
Alignment Pin Installation during Transmission/Transaxle Assembly Installation
Service Category
Drivetrain
Section
Automatic Transmission/Transaxle
Market
USA
Applicability
Introduction
The purpose of this TSB is to provide information regarding the installation of alignment pins during transmission/transaxle assembly installation.
Missing alignment pins may result in incorrect alignment and failure of the transmission/transaxle assembly. Use the information below when installing a
transmission/transaxle assembly.
Parts Information
Warranty Information
Repair Procedure
1.
Inspect the rear side of the engine block assembly for 2 alignment pins.
^
If there are less than 2 alignment pins present one may have been removed with the transmission/transaxle assembly. Check the removed
assembly for the missing alignment pins. Go to step 2.