Sienna FWD V6-3.3L (3MZ-FE) (2006)
Windshield: Service and Repair
REMOVAL
1. REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP LH
2. REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP RH
3. REMOVE FRONT PILLAR GARNISH LH
4. REMOVE FRONT PILLAR GARNISH RH
5. REMOVE VISOR ASSEMBLY LH
6. REMOVE VISOR ASSEMBLY RH
7. REMOVE ASSIST GRIP SUB-ASSEMBLY
8. REMOVE VISOR HOLDER
9. REMOVE ROOF CONSOLE BOX ASSEMBLY
10. REMOVE SUN ROOF OPENING TRIM MOULDING (W/ SLIDING ROOF)
11. REMOVE INNER REAR VIEW MIRROR ASSEMBLY
12. REMOVE ROOF HEADLINING ASSEMBLY
13. REMOVE FRONT WIPER ARM HEAD CAP
14. REMOVE FRONT WIPER ARM LH
15. REMOVE FRONT WIPER ARM RH
16. REMOVE FRONT FENDER TO COWL SIDE SEAL LH
17. REMOVE FRONT FENDER TO COWL SIDE SEAL RH
18. REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY
19. REMOVE WINDSHIELD MOULDING OUTER UPPER
a. Using a knife, cut off the moulding, as shown in the illustration.
NOTE: Do not damage the vehicle body with the knife.
b. Remove the remaining moulding.
HINT: When removing, make a partial a cut, then pull and remove it by hand.
c. w/ Deicer:
Disconnect the connector, as shown in the illustration.
20. REMOVE WINDSHIELD GLASS