Sienna FWD V6-3.3L (3MZ-FE) (2006)
a. Pass a piano wire between the vehicle body and glass from the interior.
b. Tie both wire ends to wooden blocks or similar objects.
HINT: Apply protective tape to the outer surface of the vehicle body to prevent its surface from being scratched.
NOTE:
-
When separating the glass from the vehicle, be careful not to damage the vehicle's paint or interior/exterior ornaments.
-
To prevent the safety pad from being scratched when removing the glass, place a plastic sheet between the piano wire and safety pad.
c. Cut off the adhesive by pulling piano wire around the glass.
d. Disengage the stoppers.
e. Using a suction cup, remove the glass.
NOTE: Leave as much adhesive on the vehicle body as possible when removing the glass.
21. CLEAN WINDSHIELD GLASS
a. Using a scraper, remove the damaged stoppers, dams and adhesive sticking to the glass.
b. Clean the outer circumference of the glass with white gasoline.
NOTE: Do not touch the glass surface after cleaning it.
INSTALLATION
1. INSTALL WINDSHIELD GLASS NO.2 STOPPER