Sienna FWD V6-3.3L (3MZ-FE) (2006)
HINT: After cutting off the tip, use all adhesive within the time described in the table.
2. Load the sealer gun with the cartridge.
3. Coat the glass with adhesive, as shown in the illustration.
f.
Install the glass.
1. Using a suction cup, position the glass so that the reference marks are aligned. Press it in gently along the rim.
NOTE:
-
Allow the primer coating to dry for 3 minutes or more.
-
Check that the stoppers are attached to the vehicle body correctly.
-
Check that clearance between the vehicle body and glass.
2. Lightly press the front surface of the glass to ensure a close fit.
3. Using a scraper, remove any excess or protruding adhesive.
HINT: Apply adhesive on the glass rim.