Sienna FWD V6-3.3L (3MZ-FE) (2006)
Wiper Motor: Service and Repair
Rear Wiper Motor
REMOVAL
1. REMOVE REAR WIPER ARM
a. Remove the rear wiper arm head cap from the rear wiper arm.
b. Remove the nut and the rear wiper arm.
2. REMOVE BACK DOOR GARNISH CENTER
3. REMOVE BACK DOOR SIDE GARNISH LH
4. REMOVE POWER BACK DOOR ROD
5. REMOVE BACK DOOR SIDE GARNISH RH
6. REMOVE BACK DOOR STRAP COVER
7. REMOVE BACK DOOR TRIM BOARD ASSEMBLY
8. REMOVE REAR WIPER MOTOR AND BRACKET ASSEMBLY
a. Remove the 3 bolts.
b. Disconnect the connector, and remove the rear wiper motor assembly.
INSTALLATION
1. INSTALL REAR WIPER MOTOR AND BRACKET ASSEMBLY
a. Install the rear wiper motor assembly with the 3 bolts.
Torque: 5.5 N.m (56 kgf.cm, 49 in.lbf)
b. Connect the connector.
2. INSTALL REAR WIPER ARM