Solara Coupe V6-3.3L (3MZ-FE) (2008)
Crankshaft Main Bearing Seal: Service and Repair
Installation
3MZ-FE ENGINE MECHANICAL: ENGINE REAR OIL SEAL:
INSTALLATION
1. INSTALL ENGINE REAR OIL SEAL
(a) Apply MP grease to a new oil seal lip.
NOTE: Keep the lip free from foreign matter.
(b) Using SST and a hammer, tap in the oil seal until its surface is flush with the rear oil seal retainer edge.
SST: 09223-15030
SST: 09950-70010
09951-07100
NOTICE:
-
Be careful not to tap the oil seal at an angle.
-
Wipe off extra grease from the crankshaft.
2. INSTALL DRIVE PLATE & RING GEAR SUB-ASSEMBLY
(a) Using SST, hold the crankshaft.
SST: 09213-54015
91651-60855
SST: 09330-00021
(b) Clean the bolts and bolt holes.
(c) Apply adhesive to 2 or 3 threads of the bolts.
Adhesive:
Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent
(d) Install the front spacer, drive plate and rear spacer on the crankshaft.
(e) Uniformly install and tighten the 8 bolts in the sequence shown in the illustration.
Torque: 83 Nm (846 kgf-cm, 61 ft-lbf)