Supra L6-2997cc 3.0L DOHC MFI (1998)
(4) Using SST to hold the flange, press the bearing into position by tightening down a new nut. SST 09330-00021
Torque: 181 N.m (1,850 kgf.cm, 134 ft.lbf)
(5) Loosen the nut.
(6) Torque the nut again.
Torque: 69 N.m (700 kgf.cm, 51 ft.lbf)
(7) Using a punch and hammer, stake the shaft.
(e) Install the propeller shaft.
(1) Align the matchmarks on the flanges and connect the flanges with 4 bolts, washers and nuts.
HINT: If replacing either the center flange or intermediate shaft, reassemble them so that the front yoke of the intermediate shaft and the
rear yoke of the propeller shaft are facing in the same direction.
(2) Torque the 4 bolts and nuts.
Torque: 74 N.m (750 kgf.cm, 54 ft.lbf)
2. 2JZ-GTE:
REPLACE CENTER SUPPORT BEARING
(a) Separate the intermediate shaft and propeller shaft.
(1) Place matchmarks on the intermediate shaft and propeller shaft.
(2) Separate the intermediate shaft and propeller shaft.
(3) Remove the dust boot from the propeller shaft.
HINT: If the dust boot is reused, remove it after wrapping vinyl tape around the spline, so it will not be damage.
