T100 Pickup 2WD L4-2.7L (3RZ-FE) (1994)
/Page-274004.png)
b. Using Special Service Tool (SST) 09330-00021 or equivalent, to hold the flange, remove the nut.
c. Using SST 09950-30010 or equivalent, remove the companion flange.
2. Remove front oil seal. Using SST 09308-10010 or equivalent,remove the oil seal from the differential carrier.
3. Remove front bearing and bearing spacer, as follows:
a. Using SST 09556-22010 or equivalent, remove the bearing from the drive pinion.
b. Remove the two washers and bearing spacer. If the front bearing is damaged or worn, replace the bearing.
4. Remove differential case, as follows:
a. Place matchmarks on the bearing cap and differential carrier.
b. Remove the four bolts and bearing cap.