T100 Pickup 2WD V6-3.4L (5VZ-FE) (1996)
Wheel Speed Sensor: Service and Repair
Front
FRONT SPEED SENSOR REMOVAL
1. DISCONNECT SPEED SENSOR CONNECTOR
2. REMOVE SPEED SENSOR
(a) 4WD:
-
Remove the 3 clamp bolts holding the sensor harness from the frame, upper arm and steering knuckle.
-
2WD:
-
Remove the 2 clamp bolts holding the sensor harness from the frame and upper arm.
Torque: 5 N.m (55 kgf.cm. 48 In..lbf)
(b) Remove the speed sensor from the steering knuckle.Torque: 8 N.m (80 kgf.cm. 69 in..lbf)
FRONT SPEED SENSOR INSTALLATION
-
Installation Is in the reverse order of removal.
NOTICE:
AFTER INSTALLATION. CHECK SPEED SENSOR SIGNAL-Refer to, "SPEED SENSOR AND DECELERATION SENSOR DIAGNOSIS
SYSTEM" Section.