T100 Pickup 4WD V6-3.4L (5VZ-FE) (1995)
a. Using a screwdriver, remove the four boot clamps.
b. Slide the inboard joint boot toward the outboard joint.
3. Disassemble inboard joint tulip, as follows:
a. Place matchmarks on the inboard joint tulip and drive shaft.
b. Remove the inboard joint tulip from the drive shaft.
4. Disassemble tripod, as follows:
a. Using a snap ring expander, remove the snap ring.
b. Place matchmarks on the shaft and tripod.
c. Using a brass bar and hammer, remove the tripod from the drive shaft.
5. Remove inboard and outboard joint boot clamps and boots.
NOTICE: Do not disassemble the outboard joint.
DUST DEFLECTOR REPLACEMENT
1. Remove the dust deflector. Using a screwdriver and hammer, remove the dust deflector.
2. Install a new dust deflector. Using a screwdriver and hammer, install the dust deflector.