T100 Regular Cab Pickup 2WD L4-2693cc 2.7L DOHC MFI (1998)
b. Place the flange on the shaft and align the marks.
HINT: If replacing either the center flange or intermediate shaft, reassemble it so that the front side yoke of the intermediate shaft and the rear
side flange yoke of the propeller shaft are facing in the same direction.
c. Using Special Service Tool (SST) to hold the flange, press the bearing into position by tightening down a new nut.
SST 09330-00021
Torque: 181 Nm (1,850 kgf-cm, 134 ft. lbs.)
d. Loosen the nut.
e. Torque the nut again.
Torque: 69 Nm (700 kgf-cm, 51 ft. lbs.)
f.
Using a hammer and chisel, stake the nut.
3. INSTALL PROPELLER SHAFT
a. Align the matchmarks on the flange and connect the flanges with 4 bolts, washers and nuts.
HINT: If replacing either the center flange or intermediate shaft, reassemble it so that the front side yoke of the intermediate shaft and the rear
side yoke of the propeller shaft are facing in the same direction.
b. Torque the bolts.
Torque: 74 Nm (750 kgf-cm, 54 ft. lbs.)
4. DANA-made: INSTALL CENTER SUPPORT BEARING INTERMEDIATE SHAFT