Tacoma 2WD V6-4.0L (1GR-FE) (2006)
-
Do not touch the outer belt for at least 30 minutes after the seat belt pretensioner has been activated. It is very hot.
-
Use gloves and safety glasses when handling an outer belt assembly with a pretensioner that has been activated.
-
Always wash your hands with water after completing operation.
-
Do not apply water to an outer belt assembly that has an activated pretensioner.
1. Remove the wheel and SST.
2. Place the outer belt in a plastic bag, tie the end tightly and dispose of it in the same way as other general parts.
Removal and Installation
REMOVAL
CAUTION: Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before
servicing.
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait for at least 90 seconds after disconnecting the cable to prevent the airbag from working.
2. REMOVE FRONT DOOR SCUFF PLATE
3. REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP
a. Separate the front door opening trim weatherstrip to the extent which allows the removal of the quarter trim lower panel and quarter inside trim
board.
4. REMOVE BACK PANEL TRIM COVER
5. REMOVE BACK PANEL UPPER GARNISH
6. REMOVE JACK ASSEMBLY (for Separate Seat Type)
7. REMOVE BACK PANEL TRIM COVER (for Separate Seat Type)
8. REMOVE BACK PANEL TRIM (for Separate Seat Type)
9. REMOVE QUARTER TRIM LOWER PANEL
10. REMOVE QUARTER INSIDE TRIM BOARD
11. REMOVE FRONT SEAT OUTER BELT ASSEMBLY
a. Remove the bolt and shoulder anchor.