Tacoma 2WD V6-4.0L (1GR-FE) (2006)
/Page-1327031.png)
b. Disconnect the pretensioner connector as shown in the illustration.
c. Remove the 2 bolts and retractor.
12. REMOVE FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY
a. Remove the bolt.
b. Disengage the 2 claws and remove the front shoulder belt anchor adjuster.
INSTALLATION
1. INSTALL FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY
a. Insert the 2 claws of the front shoulder belt anchor adjuster into the hole in body and mount the bolt.
Torque: 42 N.m (430 kgf.cm, 31 ft.lbf)
2. INSTALL FRONT SEAT OUTER BELT ASSEMBLY
a. Check the amount of inclination required to lock the retractor.
1. Gently incline the retractor from its initial position. Check that belt does not lock when the retractor is inclined 15 degrees or less in any
