Tacoma 2WD V6-4.0L (1GR-FE) (2006)
2. REMOVE FRONT AXLE HUB NUT
a. Using SST and a hammer, loosen the staked part of the lock nut.
SST 09930-00010
b. Attach the 3 bolts onto the hub bolt in the position shown in the illustration, and screw them into the flange, then fix them in a vice.
c. Using a socket wrench (36 mm), remove the lock nut.
d. Remove the spacer.
3. REMOVE STEERING KNUCKLE
a. Remove the 3 bolts and shift the dust cover towards the hub side (outside).
b. Using SST, remove the steering knuckle.
SST 09710-30021 (09710-03131), 09950-40011 (09951-04020, 09952-04010, 09953-04020, 09954-04010, 09955-04031, 09957-04010,
09958-04011)
c. Remove the dust cover from the axle hub.
4. REMOVE FRONT AXLE HUB OIL SEAL
a. Using a screwdriver, pry out the oil seal from the steering knuckle.
5. REMOVE FRONT AXLE HUB INNER BEARING
a. Using snap ring pliers, remove the snap ring.
b. Using SST and a press, press the bearing out of the steering knuckle.
SST 09950-60020 (09951-00710), 09950-70010 (09951-07150)
REASSEMBLY