Tacoma 4WD V6-4.0L (1GR-FE) (2006)
4. REMOVE REAR ENGINE OIL SEAL
a. Using a knife, cut off the oil seal lip.
b. Using a screwdriver, pry out the oil seal.
NOTICE: Be careful not to damage the crankshaft. Wrap the screwdriver tip with tape.
INSTALLATION
1. INSTALL REAR ENGINE OIL SEAL
a. Apply MP grease to a new oil seal tip.
b. Using SST and a hammer, tap in the oil seal until its surface is flush with the rear oil seal retainer edge.
SST 09223-78010
2. INSTALL FLYWHEEL SUB-ASSEMBLY (for Manual Transmission)
a. Using SST, hold the crankshaft.
SST 09213-54015 (91651-60855), 09330-00021
b. Apply adhesive to 2 or 3 threads of the mounting bolt end.
Adhesive: Part No. 08833-00070, THREE BOND 1324 or equivalent