Tacoma PreRunner Dbl Cab 2WD V6-3.4L (5VZ-FE) (2001)
had all rust, dirt and foreign particles cleaned off.
5. CHECK DISC THICKNESS AND RUNOUT
6. INSTALL NEW PADS
NOTICE: When replacing worn pads, the anti-squeal shims must be replaced together with the pads.
(a) Draw out a small amount of brake fluid from the reservoir.
(b) Press in the pistons with a monkey wrench handle or equivalent.
HINT:
-
Tape the monkey wrench handle before use.
-
Always change the pad on one wheel at a time as there is a possibility of the opposite piston flying out.
-
If the piston is difficult to push in, loosen the bleeder plug and push in the piston while letting some brake fluid escape.
(c) Install the anti-squeal shims to new pads.
HINT: Apply disc brake grease to both sides of inner anti-squeal shims.
(d) Install the 2 pads.
NOTICE: Do not allow oil or grease to get on the rubbing face.
7. INSTALL ANTI-RATTLE SPRING AND 2 PINS
8. INSTALL CLIP
9. INSTALL FRONT WHEEL
Torque: 103 Nm (1,050 kgf-cm, 76 ft. lbs.)
10. DEPRESS BRAKE PEDAL SEVERAL TIMES
11. CHECK THAT FLUID LEVEL IS AT MAX LINE