Tacoma PreRunner Dbl Cab 2WD V6-3.4L (5VZ-FE) (2001)
/Page-850002.png)
a. Remove the 4 screws and rectifier holder.
b. Remove the 4 rubber insulators.
5. REMOVE PULLEY
a. Hold SST (A) with a torque wrench, and tighten SST (B) clockwise to the specified torque.
SST 09820-63010
Torque: 39 N.m (400 kgf.cm, 29 ft.lbf)
b. Check that SST (A) is secured to the rotor shaft.
c. As shown in the illustration, mount SST (C) in a vise, and install the generator with SST (A) and (B) to SST (C).
d. To loosen the pulley nut, turn SST (A) in the direction shown in the illustration.
