Tacoma PreRunner Dbl Cab 2WD V6-3.4L (5VZ-FE) (2001)
NOTE: To prevent damage to the rotor shaft, do not loosen the pulley nut more than one-half of a turn.
e. Remove the generator with SST (A) and (B) from SST (C).
f.
Turn SST (B) and remove SST (A) and (B).
g. Remove the pulley nut and pulley.
6. REMOVE RECTIFIER END FRAME
a. Remove the 4 nuts.
b. Using SST, remove the rectifier end frame.
SST 09286-46011
c. Using snap ring pliers, remove the generator washer from the rectifier end frame.
7. REMOVE ROTOR FROM DRIVE END FRAME
REASSEMBLY
1. INSTALL ROTOR TO DRIVE END FRAME
a. Place the rectifier end frame on the pulley.
b. Install the rotor to the rectifier end frame.
2. INSTALL RECTIFIER END FRAME
a. Place the generator washer on the rotor.