Tacoma PreRunner Dbl Cab 2WD V6-3.4L (5VZ-FE) (2001)
b. Using a 29 mm socket wrench and press, slowly press in the rectifier end frame.
c. Install the 4 nuts.
Torque: 4.5 N.m (45 kgf.cm, 39 in.lbf)
3. INSTALL PULLEY
a. Install the pulley to the rotor shaft by tightening the pulley nut by hand.
b. Hold SST (A) with a torque wrench, and tighten SST (B) clockwise to the specified torque.
SST 09820-63010
Torque: 39 N.m (400 kgf.cm, 29 ft.lbf)
c. Check that SST (A) is secured to the pulley shaft.
d. As shown in the illustration, mount SST (C) in a vise, and install the generator with SST (A) and (B) to SST (C).
e. To torque the pulley nut, turn SST (A) in the direction shown in the illustration.
Torque: 110 N.m (1,125 kgf.cm, 81 ft.lbf)
f.
Remove the generator with SST (A) and (B) from SST (C).
g. Turn SST (B) and remove SST (A) and (B).
4. INSTALL RECTIFIER HOLDER