Tacoma PreRunner Dbl Cab 2WD V6-3.4L (5VZ-FE) (2001)
/Page-927003.png)
2. DISCONNECT RETURN HOSE
NOTICE: Take care not to spill fluid on the drive belt.
3. DISCONNECT PRESSURE FEED TUBE
a. Disconnect the connector from the oil pressure switch.
b. Remove the oil pressure switch from the pressure feed tube.
c. Remove the union bolt and 2 gaskets, and disconnect the tube from the PS vane pump assembly.
4. REMOVE DRIVE BELT
a. Loosen the bolt A and nut B.
b. Loosen the bolt C.
5. REMOVE PS VANE PUMP ASSEMBLY
Remove the bolt A and nut B.
INSTALLATION
1. INSTALL PS VANE PUMP ASSEMBLY
Temporarily tighten the bolt A and nut B.
2. INSTALL DRIVE BELT
a. Tightening the bolt C, adjust drive belt tension.
b. Torque the bolt A and nut B.
Torque: 43 Nm (440 kgf-cm, 32 ft. lbs.)
