Tacoma PreRunner Dbl Cab 2WD V6-3.4L (5VZ-FE) (2001)
/Page-946006.png)
10. REMOVE CONTROL VALVE HOUSING WITH CONTROL VALVE ASSEMBLY
a. Place matchmarks on the control valve housing and rack housing.
b. Remove the 2 bolts.
c. Pull out the control valve housing with the control valve assembly.
d. Remove the O-ring from the rack housing.
11. REMOVE CONTROL VALVE ASSEMBLY
a. Using SST, loosen the bearing guide nut.
SST 09631-20060
b. Wind vinyl tape to the control valve shaft.
c. Using a plastic hammer, tap out the control valve assembly with the bearing guide nut from the control valve housing.
NOTICE: Be careful not to damage the oil seal lip.
d. Remove the bearing guide nut from the control valve assembly.
NOTICE: Be careful not to damage the oil seal lip.
e. Remove the O-ring from the bearing guide nut.
12. REMOVE CYLINDER END STOPPER
a. Using SST, remove the cylinder end stopper.
SST 09922-10010
NOTICE: Use SST 09922-10010 in the direction shown in the illustration.
