Tacoma PreRunner Dbl Cab 2WD V6-3.4L (5VZ-FE) (2001)
a. Install a new claw washer, and temporarily install the rack end.
HINT: Align the claws of the claw washer with the steering rack grooves.
b. Using a spanner to hold the steering rack steady, and using SST, torque the rack end.
SST 09922-10010
Torque: 76 Nm (770 kgf-cm, 56 ft. lbs.)
NOTICE: Use SST 09922-10010 in the direction shown in the illustration.
HINT: Use a torque wrench with a fulcrum length of 345 mm (13.58 inch).
c. Using a brass bar and hammer, stake the claw washer.
NOTICE: Avoid any impact to the rack.
d. Employ the same manner described to the other side.
14. INSTALL RIGHT-HAND AND LEFT-HAND RACK BOOTS, CLAMPS AND CLIPS
a. Ensure that the steering rack hole is not clogged with grease.
HINT: If the steering rack hole is clogged, the pressure inside the boot will change after it is assembled and the steering wheel is turned.
b. Install the rack boot, dip and a new damp.
NOTICE: Be careful not to damage or twist the boot.